119
(2) Resetting “learned” buttons
1
2
Press the power ON button and the OFF button at the same
time.
Press the “6” button to select resetting.
Press the “2” button to resetting the “learned” buttons.
3
4
The mode buttons will all light.
5
Press the mode button you want to resetting, then press the
ENTER button.
The set returns to the normal operating mode.
(3) Resetting the system call buttons
1
2
Press the power ON button and the OFF button at the same
time.
Press the “6” button to select resetting.
Press the “3” button to resetting the system call buttons.
3
4
All buttons of System Call will light.
5
Press the button you want to resetting, then press the ENTER
button.
The set returns to the normal operating mode.
(4) Resetting the punch through setting
1
2
Press the power ON button and the OFF button at the same
time.
Press the “6” button to select resetting.
Press the “4” button to resetting the “punch through”setting.
3
4
All punched through mode buttons will light.
5
Press the mode button you want to resetting, then press the
ENTER button.
The set returns to the normal operating mode.
(5) All reset function
1
2
Press the power ON button and the OFF button at the same
time.
Press the “6” button to select resetting.
Press the “+10” button to clear the entire system memory,
which will restore the Remote control unit to the factory
default settings. This operation will take approximately 20
seconds. Only use this if you wish to clear all customized
settings and memories and restore the unit to its out-of-the-
box factory default settings.
3
To Next Page
Loading...
Need help?
General
