71
7
Enter the setting.
The Video Setup menu reappears.
(Main unit) (Remote control unit)
Select the method for playing the audio signals
included in the HDMI input signal.
Select “TV” or “AMP”.
AMP : The audio signals are played according
to the AVC-A1XV’s speaker systems.
TV : The audio signals are played according
to the number of playable channels on
the monitor TV connected to the AVC-
A1XV’s HDMI monitor output terminal.
(Main unit)
(Main unit)
(Remote control unit)
5
Select the input for the playback of signals when
the audio signal of HDMI can not be reproduced.
When the audio signal of HDMI has become
unlocked, the unit automatically changes over to
the set connector (ANALOG or EXT. IN).
1~3 correspond to each HDMI 1~3 input terminal.
Select input signal (ANALOG or EXT. IN).
(Main unit)
(Main unit)
(Remote control unit)
6
4-6. Setting the Audio Delay
• When watching a DVD or other video source, the picture on the monitor may seem delayed with respect to the sound. In this case, adjust the
audio delay to delay the sound and synchronize it with the picture.
• The audio delay setting is stored separately for each input source.
1
Select “Audio Delay” at the Video Setup menu.
2
Display the Audio Delay screen.
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
NOTE:
• If a monitor is connected with an HDMI cable
but the monitor is not compatible with HDMI
audio signal playback, only the video signals
are output to the monitor from the AVC-
A1XV (DVI mode).
Use the STATUS button to check which
mode is set for outputting HDMI signals
from the AVC-A1XV (HDMI and DVI modes).
To Next Page
Loading...
Need help?
General
