76
5-3. Setting the Auto Surround Mode
The surround mode used at last for the four types of input signals shown below is stored in the memory, and the signal is automatically played
with that surround mode the next time it is input.
Note that the surround mode setting is also stored separately for the different input sources.
q Analog and PCM 2-channel signals (STEREO)
w 2-channel signals of Dolby Digital, DTS or other multi-channel format (DOLBY PLIIx cinema)
e Multi-channel signals of Dolby Digital, DTS or other multi-channel format (DOLBY/DTS SURROUND)
r PCM and DSD multi-channel signals other than Dolby Digital and DTS (MULTI CH IN)
Default settings are indicated in ( ).
During playback in the PURE DIRECT mode, the surround mode does not change even if the input signal is changed.
1
Select “Auto Surround Mode” at the Advanced
Playback menu.
2
Display the Auto Surround Mode screen.
3
Select “ON” if you want to use the auto surround mode, “OFF” if you do not want to use it.
4
Enter the setting.
The Advanced Playback menu reappears.
(Main unit) (Remote control unit)
(Remote control unit)
Contents stored in the auto surround mode can be checked with the on-
screen display.
To Next Page
Loading...
Need help?
General
