Denon AVR-1000 User Manual

Center Mode
Center
Front right
Front feft
-, ;
eA
position
is
6
m
and
that
from
the
rear
speakers
to
the
listening
Ee
position
is
4
m,
the
optimum
delay
time
will
be
21
ms.
ae,
ae
Rear
right
The
variable
range
of
the
delay
time
differs
depending
on
the
ds
2
eee
4
mode.
2
:
5 ba x ki ol
For details about the variable range, see Page 17. sia te
— 4 2
30
3
Rear left g «
Center ne
= Front right 3 ‘Ss =
Front left = $0
£ a
WIDE mode ef
Wide mode: This mode is suited for an arrangement in which 2 8 Sr-7
the center channel speaker is of the same grade as the left and g= e
right speakers. The entire sound band from low region to high ‘Rear right 5 z =
is output to the center channel to provide an exciting sound & 2a
field for your enjoyment. =
e
e Dolby 3CH. Logic (three-channel logic mode)
Select this mode when not using rear speakers.
1. Set the Dolby Pro Logic mode.
Main unit Remote contro! unit
. Press the 3CH. LOGIC button.
ca
Main unit
3CH LOGIC
| The mode changes as shown at the left.
PRO LOGIC
. Select the center mode according to your speaker
system.
aS
Main unit
NORMAL +— WIDE
The mode changes as shown above.
NOTE:
The center mode cannot be set to the Phantom mode when
the 3CH Logic mode is set.
3CH. LOGIC MODE
Front left
@ Setting the delay time
The optimum delay time will differ depending on the listening
position. Referring to the chart at right, set the optimum delay
time for your room’s space and seating position. For example,
when the distance from the front speakers to the listening
Rear left
1. To increase the delay time:
ay
Remote control unit
2. To decrease the delay time:
XY
Remote control unit
=» Continued
Listening position and optimum delay time for playback with
Dalby Pro Logic surround
(ms)
@
0 15 30 45 60 675 «69.0 «108 12.0
Distance from the front speakers (mj
to the listening position
@ The delay time can be set between the range of 15.0ms to 30ms in steps of 1.5ms.
e
Once
the
delay
time
is
set,
there
is
no
need
to
readjust
it
unless
you
change
the
speaker
system
or
the
listening
room.
However,
when the CLEAR button is pressed, the mode changes as shown on the table on Page 18. In this case, reset the center mode.
3CH LOGIC
Three-channel logic mode: Use this mode when rear channel
speakers are not used. The rear channel information is
reproduced by the front speakers.
15

Denon AVR-1000 Specifications

General

Brand	Denon
Model	AVR-1000
Category	Stereo Receiver
Language	English