Denon AVR-1000 User Manual

@ Using the Personal Memory
Surround
mode
settings
and
the
input
function
can
be
stored
at
personal
memory
buttons
“1”
and
“2”,
then
recalied
directly
from
any
surround
mode
simply
by
pressing
button
“1”
or
“2”.
ith} Storing the setting in the personal memory
1. Set the desired surround mode and input function.
2. Press the personal memory button.
MEMORY
Remote controt unit
(The memory setting mode is set and the indicator on
the MFD flashes.)
. Press the desired personal memory button (“1 or “2”).
’ 2
Ca-co
Remote control unit
. "M1 (2) SET” appears on the MFD indicating that the
setting has been stored.
NOTE:
@ The memory setting mode is set for 6 seconds. if any
button other than personal memory button “1” or “2” is
pressed, the memory setting mode is cancelled.
[2] Recalling the personal memory
5. Press the personal memory button (“1" or “2*) at which
the desired setting was stored.
mrcs
Remote contro! unit
6. The surround mode and input function switch automati-
cally.
NOTES:
@ Personal memory buttons “1” and “2” will not function during the tape monitor mode.
e The surround mode recalled with the PERSONAL MEMORY “1” or “2” button is the same as the mode selected with the surround
mode button. Thus, if the parameters of the surround mode which was stored in the memory are cleared, when the mode is recalled
it is set to the initial values.
e Upon shipment from the factory, the “WIDE SCREEN” mode is stored at personal memory “1”, the “LIVE” mode at personal
memory “2”. The input function is set to VDP/DBS for both “1” and “2”.
© Do not press personal memory buttons “1” or "2" buttons during recording on the cassette deck.
PRINS ETT
@ Operations Possible in the Various Surround Modes
The
following
is
a
list
of
the
buttons
and
functions
which
can
be
operated
during
the
different
surround
modes.
Figures
in
parentheses
indicate
adjustment
ranges.
=
QUTPUT j CENTER LEVEL | REAR LEVEL CENTER ate TES, DELAY TIME
+ | _—
x x x
BYPASS
O°
x
x
x
NORMAL ie} O (0~~-24dB) O (0~-24dB) ie) oO Oo O (15~30ms)
DOLBY
PRO
LOGIC
PHANTOM
eo}
x
ie}
©
(15~30ms}
e) O (0~-24d8) | O (0~-240B) oO oO [o} O (15~30ms)
NORMAL Oo © (0~-24d8) x ie} oO eo) x
DOLBY 3CH LOGIC ot
ce]
O
(0~~24dB)
x
o
ie}
ie)
x
j
WIDE
SCREEN
NORMAL
fe)
O
(0~-24d8)
O
{0~-24dB)
(e}
x
x
O
(6~30ms)
ah
&
PHANTOM
{e}
x
O
(0~-240B)
ie}
x
x
O
(6~30ms)
© (6~30ms}
LIVE
WIDE
°
©
(0~--24dB)
O
(0~~-240B
eo)
x
x
~
i a Fila -
MONO
MOVIE
Oo
x
O
(0~—24dB)
a"
x
x
x
——__—_+
CLASSIC
CONCERT
oO
x
©
(0~-24dB)
a"
x
x
x
— as
ROCK
CONCERT
oO
x
O
(0~-24dB)
S
x
x
x
STADIUM
{e}
x
O
(0~-24d8)
a"
x
x
x
DAT/TAPE
EFFECT
LEVEL
cLR
“MEMORY”
MONITOR
ees
S
BYPASS
ae
Re
x
2
c
NORMAL
o
2
xx
DOLBY PRO LOGIC
5 0
WIDE Eee ee oe
NORMAL
DOLBY 3CH LOGIC
WIDE x
WDE SOREN
& PHANTOM O (5~15)
uve woe | Ow | oo [0 |
[WoO MOVE | ew | oO TO
fewassc concerts Sid oe [| oo | o | o |
ROCK CONCERT O (5~15) ie]
x
x
OJO;OJOJO]O
°
OlO|O};O
QO
{eo}
oO
ie}
le}
Oo
oO
ie)
°
°
(e)
O: Operation possible
X: Operation not possible
"’
Switches
to
the
Dolby
Pro
(3CH)
Logic
mode
for
any
modes
other
than
Dolby
Pro
(3CH)
Logic,
Wide
Screen
and
LIVE.
“2
Personal
memory
buttons
MEMORY’
“1”
and
“2”
will
not
function
during
the
DAT/tape
monitor
mode.
@
The
sound
may
be
distorted
for
some
sources
if
the
rear
level
or
effect
level
is
raised
during
surround
playback.
If
this
happens,
lower
the
rear
level
and
effect
level.
[12] LAST FUNCTION MEMORY
«
This
receiver
is
equipped
with
a
jast
function
memory
which
stores
the
input
and
output
setting
conditions
as
they
were
immediately
before
the
power
is
switched
off.
This
function
eliminates
the
need
to
perform
complicated
resettings
when
the
power
is
switched
on.
©
This
receiver
is
also
equipped
with
a
back-up
memory.
This
function
provides
approximately
one
week
of
memory
storage
with
the
power
cord
disconnected.
17

Denon AVR-1000 Specifications

General

Brand	Denon
Model	AVR-1000
Category	Stereo Receiver
Language	English