Denon AVR-1610 - Playback; Operation Flow; Playing Components; Playing Blu-Ray Disc; DVD Players


ENGLISH
Getting Started
Connections Remote Control Information Troubleshooting
SpecificationsSettings
Playback
Playing Components
1
Prepare for playback.
 ①Turn on the power of the TV, subwoofer
and player.
  ②Set the TV’s input to the AVR-1610.
  ③Load the disc in the player.
2
Turn on the AVR-1610’s power.
(vpage 16“Turning the Power On”)
3
Press and select the input
source.
If “TUNING PRESET” is selected for preset
channel, press before turning .
4
Play the component connected to the AVR-1610.
Make the necessary settings on the player (language
setting, subtitles setting, etc.) beforehand.
5
Use to adjust the volume.
GVariable rangeH
– – – –80.0dB ~ 18.0dB
※The variable range differs according to the input signal and channel
level setting.
6
Select the desired surround mode.
(vpage 37“Selecting the Surround Mode”)
7
Adjust the desired sound eld effects.
(vpage 39“Adjusting the Sound Field Effects”)
The following describes the procedure for playing Blu-ray disc/
DVD players.
Use the same procedure to play other components.
Playing Blu-ray Disc / DVD Players
The music / video on an iPod can be played by using the control
dock for iPod (ASD-1R, ASD-11R, ASD-3N or ASD-3W sold
separately).
Connect the control dock for iPod beforehand. (vpage 14
“iPod
®
”).
iPod
®
Playback
1
Prepare for playback.
q Set the iPod in the DENON control
dock for iPod.
w Assign the control dock for iPod’s input
(vpage 31).
 eSwitch to “DEVICE”.
2
Turn on the AVR-1610’s power.
(vpage 16“Turning the Power On”)
3
Press to select the input
source assigned in step 1-w
above.
b If the screens above are not
displayed, the iPod may not be
properly connected. Try connecting
again.
(iPod screen)
Listening to music on an iPod
®
OK to disconnect.
Adjusting the Sound Field Effects (Parameter)
(vpage 39)
Playing Components (vpage 34)
n Playing Blu-ray Disc/DVD Players (vpage 34)
n iPod® Playback (vpage 34)
n Listening to FM/AM Broadcasts (vpage 36)
n Operations During Playback (vpage 37)
n Operation Flow
 Before starting playback, make the connections between the
different components and the settings on the receiver.
Selecting the Surround Mode (vpage 37)
q Standard Playback (vpage 37)
w Playing in a DENON original surround mode
(vpage 38)
e Direct Playback (vpage 38)
r Stereo Playback (vpage 39)
NOTE
●Also refer to the operating instructions of the connected
components when playing them.
●External devices can be controlled by remote control unit
(vpage 46 “Operating the Connected Devices by Remote
Control Unit”).
See overleaf
Playback