Denon AVR-1610 - Operations During Playback; Selecting the Surround Mode; Playing Sources According to the Sources Audio Signal Format;Number of Channels (Standard Playback)


ENGLISH
Getting Started Connections Remote Control Information Troubleshooting SpecificationsSettings
Playing Components
Turning Off the Sound Temporarily (Muting)
Press .
The sound is reduced to the level set at menu “Mute Level” (vpage
28).
To cancel, press again. Muting can also be canceled by adjusting
the master volume.
•
•
Listening with Headphones
Plug the headphones into the PHONES
jack on the main unit.
The sound from the speakers and pre-out
connectors is automatically cut.
NOTE
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
Unplug headphones when performing the Audyssey Auto Setup
procedure or other settings.
•
•
Switching the front speakers
Press .
Front A Front B
Front A+B
NOTE
When you set to “Custom” with “Front Speaker Setup“ (vpage 27),
you cannot operate .
Operations During Playback
Selecting the Surround Mode
Select a surround mode to enjoy surround playback with your favorite sound field effects.
q Playing sources according to the sources’ audio signal format/number of channels
(Standard Playback)
1
Playing the source (vpage 34).
2
Press to select the surround
mode.
n Multichannel sources
The surround modes that can be selected
differ according to the input source.
n 2channel sources
When you select “DOLBY PLgz”, set “Pre
Assign” to “Front Height”.
DOLBY PLgx,
DOLBY PLg
or
DOLBY PLgz
: The signals are decoded in DOLBY PLgx,
DOLBY PLg or DOLBY PLgz, for playback.
DTS NEO:6
: The signals are decoded in DTS NEO:6 for
playback.
z
: DOLBY PLgx can be selected when surround back speakers are
being used.
Operations
The selectable surround modes depend on the following:
• Format of the audio signals being input
• Number of channels of the audio signals being input
• The set pre out assignment mode (vpage 24)
3

Select the mode for the source at “Mode” (
vpage
39).
n DOLBY PLgx, DOLBY PLg
Cinema
: This mode is suited for movie sources.
Music
: This mode is suited for music sources.
Game
: This mode is suited for games.
Pro Logic
: This is the Pro Logic playback mode. This can be
selected when playing with a DOLBY PLg decoder.
When this mode is selected, “DOLBY PL” is
displayed.
n DTS NEO:6
Cinema
: This mode is suited for movie sources.
Music
: This mode is suited for music sources.
※The modes that can be selected depend on the input source
being played.
The “Cinema” and “Music” modes can also be set by pressing
or .
This is the operation for playing 2-channel sources.
z
Switching the brightness of the display
Press
.
Bright Dim
DarkOFF
Playback