Denon AVR-1912

58
Surround mode
Surr.Parameter
Tone
z15
Audyssey Settings
z17
RESTORER
z20
Height Gain
PLgz Height
z13
AFDM
z14
S.Back Subwoofer
PRO LOGIC g/gx Music mode only
NEO:6 Music
mode only
Panorama Dimension C.Width C.Image MultEQ
®
XT
Dynamic EQ
®
z18
Dynamic
Volume
®
z19
DIRECT/PURE DIRECT (2channel)
z1
S
z4
DIRECT/PURE DIRECT (Multi-channel)
z1
STEREO
S S S S S
MULTI CH IN
S
z12
S S S S S
DOLBY PRO LOGIC gz S S S S S S S
DOLBY PRO LOGIC gx S S S S S S S S S
DOLBY PRO LOGIC g S S S S S S S S S
DTS NEO:6
S S S S S S S
DOLBY DIGITAL
S
z12
S S S S S S S
DOLBY DIGITAL Plus
S
z12
S S S S S S S
DOLBY TrueHD
S
z12
S S S S S S S
DTS SURROUND
S
z12
S S S S S S S
DTS 96/24
S
z12
S S S S S S S
DTS-HD
S
z12
S S S S S S S
DTS Express
S
z12
S S S S S S
MULTI CH STEREO
S S S S S
ROCK ARENA
S
z16
S S S S
JAZZ CLUB
S S S S S
MONO MOVIE
S S S S S
VIDEO GAME
S S S S S
MATRIX
S S S S S
VIRTUAL
S S S S S
z1 During playback in PURE DIRECT mode, the surround parameters are the same as in DIRECT mode. z4 Only when “Subwoofer Mode” is set to “LFE+Main”, sound is output from the subwoofer. z12 This item can be selected when “Surr.Parameter” – “PLgz Height” is set to “ON”. z13 If “Speaker Config.” – “F.Height” is set to “None”, this item cannot be selected. z14 This item can be selected when a Dolby Digital or DTS signal is played. z15 This item cannot be set when “Dynamic EQ
®
” is set to “ON”.
z16 In this surround mode, bass is +6 dB, and treble is +4 dB. (Default) z17 For HD Audio whose sampling frequency of an input signal is more than 96 kHz, this sound parameter cannot be set. z18 This item cannot be set when “MultEQ
®
XT” is set to “OFF” or “Manual”.
z19 This item cannot be set when “Dynamic EQ
®
” is set to “OFF”.
z20 This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.