133
Video
On Screen Display
Default settings are underlined.
Select the on-screen display user interface preferences.
Setting items Setting details
Volume
Sets where to display the
master volume level.
Bottom : Display at the bottom.
Top : Display at the top.
Off : Turn display off.
When the master volume display is hard to see when superimposed
on movie subtitles, set to “Top”.
Info
Displays status of operation
temporarily when the sound
mode is changed, or input
source is switched. You
can set whether or not to
show each of these status
displays.
On : Turn display on.
Off : Turn display off.
Now Playing
Sets how long each menu
is displayed when the input
source is “NETWORK”,
“iPod/USB”, or “HDRadio”.
Always On : Show display continuously.
Auto Off : Show display for 30 seconds after operation.
TV Format
Default settings are underlined.
Set the video signal format to be output for the TV you are using.
Setting items Setting details
Format
NTSC : Select NTSC output.
PAL : Select PAL output.
“Format” can also be set by the following procedure. However, the menu
screen is not displayed.
1. Press and hold the main unit’s o p for at least 3 seconds.
“zVideo Format < NTSC >” appears on the display.
2. Use the main unit’s o p and set the video signal format.
3. Press the main unit’s ENTER to complete the setting.
NOTE
When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
To Next Page
Loading...
Need help?
General
