168
Setting the back light
You can set the back light on the remote control unit to off to prolong
the life of the dry cell batteries.
1
Press and hold RC SETUP for at
least 3 seconds.
“SETUP” and indicator flashes twice
on the remote control unit.
2
Use ui to display “LIGHT” on
the remote control unit and press
ENTER.
3
Use ui to set the back light and
press ENTER.
Remote control unit display Back light
ON Back light on
OFF Back light off
Restoring all settings of the remote
control unit to default
Use the following procedure to restore all default settings of the
remote control unit at the time of purchase.
1
Press and hold RC SETUP for at
least 3 seconds.
“SETUP” and indicator flashes twice
on the remote control unit.
2
Use ui to display “RESET” on
the remote control unit and press
ENTER.
3
Use ui to display “ALL” on
the remote control unit and press
ENTER.
4
Use ui to display “YES” on the remote control unit
and press ENTER.
“RESET” flashes four times on the remote control unit and the
normal operation mode is restored.
To Next Page
Loading...
Need help?
General
