Denon AVR-887 User Manual

ENGLISH
ENGLISH
Easy Setup Procedure Easy Setup Procedure
13
MeasuresCauseExample
q This screen will be displayed when the speakers required
for producing suitable reproduction have not been detected.
• Check that the pertinent speakers are properly connected.
w This screen will be displayed when the speaker polarity is
connected in reverse.
• Check the polarity of the pertinent speakers. For some
speakers, this screen may be displayed even though the
speakers are properly connected.
If so, select “Skip
0 ”.
e This screen will be displayed when accurate measurements
cannot be made due to the input level of the microphone being
too high.
• Set up the speakers so that their position is farther away
from the listening position.
• Lower the volume of the subwoofer speaker.
Error messages
• These error screens may be displayed when performing Auto Setup measurement and the automatic measurements can not be completed
because of the speaker arrangement, measurement environment, or other factors. Please check the following matters, reset the pertinent
items, and measure again.
• When there is too much noise in the room, the speakers may not be detected properly. Should this happen, perform the measurements when
the noise level is low, or switch off the power of the equipment that is producing the noise for the duration of the measurements.
Press
DD HH
to select the items, then press
FF
.
r This screen will be displayed when the measurement
microphone is not connected.
• Connect the measurement microphone to the microphone
connector.

Denon AVR-887 Specifications

Power

rated output front	100 W + 100 W (8 ohms, 20 Hz - 20 kHz, 0.08 % THD)
rated output front alternative	135 W + 135 W (6 ohms, 1 kHz, 0.7 % THD)
rated output center	100 W (8 ohms, 20 Hz - 20 kHz, 0.08 % THD)
rated output center alternative	135 W (6 ohms, 1 kHz, 0.7 % THD)
rated output surround	100 W + 100 W (8 ohms, 20 Hz - 20 kHz, 0.08 % THD)
rated output surround alternative	135 W + 135 W (6 ohms, 1 kHz, 0.7 % THD)
rated output surround back	100 W + 100 W (8 ohms, 20 Hz - 20 kHz, 0.08 % THD)
rated output surround back alternative	135 W + 135 W (6 ohms, 1 kHz, 0.7 % THD)
power supply	AC 120 V, 60 Hz
power consumption	5.5 A

Audio Inputs and Outputs

analog inputs	9 sets
analog ext inputs	8
digital inputs optical	4
digital inputs coaxial	2
audio delay function	0 - 200 msec.
variable subwoofer crossover	40/60/80/90/100/110/120/150/200/250 Hz

Video Inputs and Outputs

component video inputs	3 sets
composite inputs	5
s-video inputs	5
component video outputs	1 set
composite outputs	3
s-video outputs	3

Audio Performance

frequency response	10 Hz - 100 kHz (+1, -3 dB)
signal-to-noise ratio	100 dB (IHF-A weighted)
tone control treble	±6 dB at 10 kHz
tone control bass	±6 dB at 100 Hz

Weight and Dimensions

dimensions	17-3/32” (W) x 6-47/64” (H) x 16-27/64” (D)
dimensions metric	434 (W) x 171 (H) x 417 (D) mm
weight	29 lbs 5 oz
weight metric	13.0 kg