Denon AVR-891 - Playback in ZONE2 (Separate Room); Audio Output; Various Memory Functions

39
ENGLISH
Basic versionSimple version InformationAdvanced version
Playback in ZONE2 (Separate room)
• You can operate this unit so as to enjoy audio in a room (ZONE2)
other than the MAIN ZONE (room where the unit is located).
• You can simultaneously play back the same source in both the MAIN
ZONE and ZONE2. You can also play back separate sources in the
MAIN ZONE and ZONE2.
Audio output
ZONE2 playback by speaker output
The ZONE2 audio signals are output from this unit’s SURR. BACK/AMP
ASSIGN speaker terminals using the amplifier assignment function.
n Connecting and setting the speakers
“Amp Assign” setting
(vpage 55) and audio
signals output
Connecting the speakers
ZONE2
Output signal :
Stereo (L / R)
MAIN ZONE
ZONE2
This unit
We recommend using high quality pin-plug cables for audio
connections in order to prevent noise.
NOTE
• It is not possible to play the digital audio signals input from the
HDMI, COAXIAL or OPTICAL connectors in ZONE2. Use analog
connections for ZONE2 playback.
• Video output is not available in ZONE2.
Convenient functions
Various memory functions
n Personal memory plus function
This function sets the settings (input mode, surround mode, HDMI
output mode, MultEQ, Dynamic EQ, Dynamic Volume, audio delay
etc.) last selected for the individual input sources.
The surround parameters, tone settings and the volumes of the
different speakers are stored for the individual surround modes.
n Last function memory
This function stores the settings which were made before going
into the standby mode.
When the power is turned back on, the settings are restored.