Denon AVR-891 - Surround Sound Modes and Parameters Table

74
ENGLISH
Surround
Surround mode (vpage26)
Surround Parameter (vpage50)
Tone
z15
(vpage51)
Audyssey Settings
z20
(vpage52)
RESTORER
z19
(vpage54)
AFDM
z12
(vpage50)
S.Back
(vpage51)
F.Height
z13
(vpage51)
Height Gain
(vpage51)
Subwoofer
(vpage51)
PRO LOGIC g/gx Music mode only
NEO:6 Music
mode only
Panorama
(vpage50)
Dimension
(vpage50)
C.Width
(vpage50)
C.Image
(vpage50)
MultEQ
®
(vpage52)
Dynamic EQ
®
z17
(vpage52)
Dynamic
Volume™
z18
(vpage53)
PURE DIRECT
S
z3
DIRECT (2 channel)
S
z3
DIRECT (Multi-channel)
STEREO
S S S S S
MULTI CH IN
S S S S
z14
S S S S
DOLBY PRO LOGIC gz S S S S S S S
DOLBY PRO LOGIC gx S S S S S S S S S
DOLBY PRO LOGIC g S S S S S S S S S S
DTS NEO:6
S S S S S S S
DOLBY DIGITAL
S S S S
z14
S S S S
DOLBY DIGITAL Plus
S S S S
z14
S S S S
DOLBY TrueHD
S S S S
z14
S S S S
DTS SURROUND
S S S S
z14
S S S S
DTS 96/24
S S S S
z14
S S S S
DTS-HD
S S S S
z14
S S S S
DTS Express
S S S S
z14
S S S S
MULTI CH STEREO
S S S S S S S
ROCK ARENA
S S S
z16
S S S S
JAZZ CLUB
S S S S S S S
MONO MOVIE
S S S S S S S
VIDEO GAME
S S S S S S S
MATRIX
S S S S S S S
VIRTUAL
S S S S S
z3 Only when “SW Mode” is set to “LFE+Main” (vpage56), sound is output from the subwoofer.
z12 This item can be selected when a Dolby Digital or DTS or DVD-Audio signal is played.
z13 If “Speaker Config.” – “F.Height” (vpage56) is set to “None”, this item cannot be selected.
z14 This item can be selected when “Surround Parameter” – “F.Height” (vpage51) is set to “ON”.
z15 This item cannot be set when “Dynamic EQ” (vpage52) is set to “ON”.
z16 In this surround mode, bass is +6 dB, and treble is +4 dB. (Default)
z17 This item cannot be set when “MultEQ” (vpage52) is set to “OFF” or “Manual”.
z18 This item cannot be set when “Dynamic EQ” (vpage52) is set to “OFF”.
z19 This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
z20 For HD Audio whose sampling frequency of an input signal is more than 96 kHz, this sound parameter cannot be set.