Denon AVR-891 - Power On and Audyssey Auto Setup; Calculation and Analysis Phase; Checking Measurement Results; Saving Audyssey Setup Results

6
ENGLISH
Set up speakers
(Audyssey
®
Auto Setup)
1 2 4 53
4
The “Simple version” describes the installation, connection and setup methods for 5.1-channel speakers.
See page 30 for the installation, connection and setup methods for speakers other than 5.1-channel speakers.
The acoustic characteristics of the connected speakers and listening room are
measured and the optimum settings are made automatically. This is called
“Audyssey Auto Setup”.
To perform measurement, place the setup microphone in multiple locations all
around the listening area. For best results, we recommend you measure in six
positions, as shown in the illustration (up to six positions).
• When performing Audyssey Auto Setup, MultEQ
®
/Dynamic EQ
®
/Dynamic
Volume™ functions become active (vpage52, 53).
• To set up the speakers manually, use “Speaker Setup” (vpage55) on the menu.
NOTE
• Make the room as quiet as possible. Background noise can disrupt the room measurements. Close
windows, silence cell phones, televisions, radios, air conditioners, fluorescent lights, home appliances,
light dimmers, or other devices as measurements may be affected by these sounds.
• Cell phones should be placed away from all audio electronics during the measurement process as Radio
Frequency Interference (RFI) may cause measurement disruptions (even if the cell phone is not in use).
• Do not unplug the setup microphone from the main unit until Audyssey Auto Setup is completed.
• Do not stand between the speakers and setup microphone or allow obstacles in the path while the
measurements are being made. This will cause inaccurate readings.
• Loud test sounds may be played during Audyssey Auto setup. This is part of
normal operation. If there is background noise in room, these test signals will
increase in volume.
• Operating
VOL df during the measurements will cancel the measurements.
• Measurement cannot be performed when headphones are connected.
Turn on power
1 2 4 53
3
1
Turn on the TV and subwoofer
power.
Power on
2
Change the TV input to the input of
this unit.
3
Press POWER ON to turn on power
to the unit.
The power indicator flashes green and the
power turns on.
Power on
Power on