HDCP2.2 / HDR / Deep Color / Dolby Vision /
DTS:X / Dolby Atmos / PCM 2ch only
You can set a limit of each funcition of the AV Receiver according to your situation.
No Limit
(Default):
No limit.
Limit: Limit (Disable) each function by changing EDID and HDCP
setting information.
Reset
You can reset the limit mode settings to the factory default values.
Settings other than limit mode are not reset.
Current source ***: Reset the limitation setting only for the current source.
All sources: Reset the limitation setting for all sources.
Cancel: Cancel this menu and go back to the limitation mode
selection menu.
(** is current source name)
0
You can reset the default settings by setting “Factory Reset mode”. (v p. 8)
Please note that the Limit Mode setting will not be reset by performing the process described
in “Resetting factory settings” in the owner’s manual.
0
You can easily check whether HDMI-related functions are limited for the currently selected
input source in the AVR Setup Menu-General – Information – ZONE – MAIN ZONE.
“HDMI Limitation Mode – 4K Standard” is displayed when the 4K Signal Format is set to
“Standard” (4K3G).
“HDMI Limitation Mode – On” is displayed when any of the settings are limited in the HDMI
Diagnostics Limitation Mode.
These are not displayed when there are no limitations.
Introduction How to operate Cable Test Limit mode Log & EDID Troubleshooting
14
To Next Page
Loading...
Need help?
General
