Denon AVR-S730H Troubleshooting Guide

Appendix
Note1: Source Device check item
0
(Try) AC Off/On
0
(Try) Standby/Power On
0
(Check or change) Video setting (Resolution, etc...)
0
(Check or change) Output Terminal setting (case of Dual output source device)
0
Video check (connect the HDMI cable from Source device to the Monitor
directly without the AV Receiver.)
Note 2: AV Receiver check item
0
Menu Setting
Video N HDMI Setup N HDMI Audio Out
Video N Output Settings N HDMI Video Output
Video N Output Settings N I/P Scaler
Video N Output Settings N Resolution
Video N TV Format
Inputs N Input Assign
0
Connection [Source device / AV Receiver / Monitor device]
Note3: Monitor Device check item
0
(Try) AC Off/On
0
(Try) Standby/Power On
0
(Check or change) HDCP Ver. setting
0
(Check or change) EDID (4K Limitation) setting
0
(Check or change) limit of each HDMI input terminal
0
Video check (connect the HDMI cable from Source device to the Monitor
directly without AV Receiver.)
Note 4: Try Limit Mode
0
Max Resolution setting
Set a lower resolution
NoLimit N 4K(3G) N 1080p N 720p N 480p
0
Deep Color setting
Set a “Limit”
Introduction How to operate Cable Test Limit mode Log & EDID Troubleshooting
40

Denon AVR-S730H Specifications

General

Channels	7.2
Power Output (6 ohm, 1 kHz, 0.7% 2ch Drive)	110W
Power Output (6 ohm, 1 kHz, 10% 1ch Drive)	165W
HDMI Inputs	6
HDMI Outputs	1
Dolby Atmos	Yes
DTS:X	Yes
DTS Virtual:X	Yes
Wi-Fi	Yes
Bluetooth	Yes
HEOS Multi-room	Yes
4K Ultra HD Pass-through	Yes
HDR Support	Yes (HDR10, Dolby Vision, HLG)
Auto Speaker Calibration	Audyssey MultEQ
AirPlay	Yes (AirPlay 2)
Internet Radio	Yes
Phono Input	No
Ethernet Port	Yes
Power Output per Channel	75W (8 ohm, 20Hz-20kHz, 0.08% 2ch Drive)
USB Input	1 (Front)