Denon AVR-S730H Troubleshooting Guide

Initialization
The Limit setting in the HDMI DIAGNOSTICS mode is stored per input.
Please note that the limit mode settings backup memory will not be initialized (reset) using the initialization (reset) method described in the instruction manual.
There are two ways to reset the limit mode settings.
Reset option in HDMI DIAGNOSTICS mode
Limit mode settings that are made in the HDMI Diagnostics mode are reset to the
factory default values.
However, settings other than HDMI Diagnostics (e.g. Speaker setup, Video Setup,
Audio Setup) are not reset.
1
Select "5 Limit Mode" from the HDMI Diagnostics menu.
2
Select "Reset" from the Limit mode menu.
3
Select ”All source", then press ENTER.
Factory Reset mode
All settings including the Limit mode setting of HDMI Diagnostics mode are reset to
the factory default values. (except for Network setup)
1
Press the POWER button to turn off the AV Receiver.
2
While holding down buttons [A] and [B] simultaneously, press
POWER button.
3
Release the buttons after confirming that the front panel display
flashes at 1-second intervals.
Model Button [A] Button [B]
AVR-S730H
AVR-S930H
TUNER
PRESET CH +
TUNE -
AVR-X1400H
AVR-X2400H
ZONE2 SOURCE DIMMER
Introduction How to operate Cable Test Limit mode Log & EDID Troubleshooting
8

Denon AVR-S730H Specifications

General

Channels	7.2
Power Output (6 ohm, 1 kHz, 0.7% 2ch Drive)	110W
Power Output (6 ohm, 1 kHz, 10% 1ch Drive)	165W
HDMI Inputs	6
HDMI Outputs	1
Dolby Atmos	Yes
DTS:X	Yes
DTS Virtual:X	Yes
Wi-Fi	Yes
Bluetooth	Yes
HEOS Multi-room	Yes
4K Ultra HD Pass-through	Yes
HDR Support	Yes (HDR10, Dolby Vision, HLG)
Auto Speaker Calibration	Audyssey MultEQ
AirPlay	Yes (AirPlay 2)
Internet Radio	Yes
Phono Input	No
Ethernet Port	Yes
Power Output per Channel	75W (8 ohm, 20Hz-20kHz, 0.08% 2ch Drive)
USB Input	1 (Front)