Name: Denon AVR-S900W
Brand: Denon
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Bass

Set subwoofer and LFE signal range playback.

Subwoofer Mode

Select low range signals to be reproduced by subwoofer.

LFE

(Default):

The low range signal of the channel set to

“Small” speaker size is added to the LFE

signal output from the subwoofer.

LFE+Main:

The low range signal of all channels is

added to the LFE signal output from the

subwoofer.

“Subwoofer Mode” can be set when “Speaker Config.” - “Subwoofer” is set to

other than “No”. (v

p. 179)

Play music or a movie source and select the mode offering the strongest bass.

If “Speaker Config.” - “Front” and “Center” are set to “Large”, and “Subwoofer

Mode” is set to “LFE”, no sound may be output from the subwoofers,

depending on the input signal or selected sound mode. Select “LFE+Main” if

you want the bass signals to always be produced from the subwoofer.

(v p. 179)

LPF for LFE

Set LFE signal playback range. Set this when you want to change the

playback frequency (low pass filter point) of the subwoofer.

80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 200 Hz / 250 Hz

(Default : 120 Hz)

Contents Connections Playback Settings Tips Appendix

184

Front panel Display Rear panel Remote Index

Other manuals for Denon AVR-S900W

Questions and Answers:

Need help?

Do you have a question about the Denon AVR-S900W and is the answer not in the manual?

General