Denon AVR-S900W User Manual

o
Noise Reduction
Reduce overall video noise.
Low / Medium / High / Off (Default : Off)
o
Enhancer
Emphasize picture sharpness.
0 – +12 (Default : 0)
HDMI Setup
Make settings for HDMI video/audio output.
NOTE
When “HDMI Pass Through” and “HDMI Control” is set to “On”, it consumes more
standby power. If you are not using this unit for an extended period, it is
recommended that you unplug the power cord from the power outlet.
o
Auto Lip Sync
Make automatic compensation for timing shift in audio and video
output.
On
(Default):
Correct automatically.
Off: Do not correct automatically.
Contents Connections Playback Settings Tips Appendix
154
Front panel Display Rear panel Remote Index

Denon AVR-S900W Specifications

General

Channels	7.2
HDMI Inputs	8
HDMI Outputs	2
Wi-Fi	Yes
Bluetooth	Yes
4K Ultra HD Pass-through	Yes
Dolby Atmos	Yes
DTS:X	No
HDMI Pass-Through	Yes
Input Impedance	47 kOhm
Input Sensitivity	200 mV
THD at rated output	0.08%
Signal-To-Noise Ratio	98 dB
DAC Resolution	24-bit / 192kHz
HDMI Switching	Yes
AirPlay	Yes
DLNA	Yes
Dimensions	17.1 x 6.6 x 13.3 inches
Power Output	90 W
Response Bandwidth	10Hz-100kHz
Output Impedance / Channel	6 Ohm
Inputs	HDMI
Outputs	HDMI
Supported Audio Formats	MP3, WMA, AAC, FLAC, WAV
Supported Video Formats	4K
Output Power / Channel	90W (8 ohms, 20Hz-20kHz, 0.08% THD)