EasyManuals Logo

Denon AVR-S900W User Manual

Denon AVR-S900W
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Inserting the batteries
1
Remove the rear lid in the direction of the arrow and
remove it.
.
2
Insert two batteries correctly into the battery
compartment as indicated.
.
R03/AAA batteries
3
Put the rear cover back on.
NOTE
0
To prevent damage or leakage of battery fluid:
0
Do not use a new battery together with an old one.
0
Do not use two different types of batteries.
0
Remove the batteries from the remote control unit if it will not be in use for long
periods.
0
If the battery fluid should leak, carefully wipe the fluid off the inside of the battery
compartment and insert new batteries.
Operating range of the remote control
unit
Point the remote control unit at the remote sensor when operating it.
.
Approx. 23 ft/7 m
30° 30°
Contents Connections Playback Settings Tips Appendix
8
Front panel Display Rear panel Remote Index

Table of Contents

Other manuals for Denon AVR-S900W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-S900W and is the answer not in the manual?

Denon AVR-S900W Specifications

General IconGeneral
Channels7.2
HDMI Inputs8
HDMI Outputs2
Wi-FiYes
BluetoothYes
4K Ultra HD Pass-throughYes
Dolby AtmosYes
DTS:XNo
HDMI Pass-ThroughYes
Input Impedance47 kOhm
Input Sensitivity200 mV
THD at rated output0.08%
Signal-To-Noise Ratio98 dB
DAC Resolution24-bit / 192kHz
HDMI SwitchingYes
AirPlayYes
DLNAYes
Dimensions17.1 x 6.6 x 13.3 inches
Power Output90 W
Response Bandwidth10Hz-100kHz
Output Impedance / Channel6 Ohm
InputsHDMI
OutputsHDMI
Supported Audio FormatsMP3, WMA, AAC, FLAC, WAV
Supported Video Formats4K
Output Power / Channel90W (8 ohms, 20Hz-20kHz, 0.08% THD)

Related product manuals