EasyManuals Logo

Denon AVR-S900W User Manual

Denon AVR-S900W
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #199 background imageLoading...
Page #199 background image
o
Add New Feature
Display new features that can be downloaded to this unit and perform
an upgrade.
Upgrade
Package:
Display the items to be upgraded.
Upgrade
Status:
Display a list of the additional functions provided by
the upgrade.
Upgrade Start:
Execute the upgrade process.
When the upgrade starts, the menu screen is shut
down. During the upgrade, the amount of upgrade
time which has elapsed is displayed.
0
See the Denon website for details about upgrades.
0
When the procedure is complete, “Registered” is displayed in this menu and
upgrades can be carried out. If the procedure has not been carried out, “-------”
is displayed.
The ID number shown on this screen is needed when carrying out the
procedure.
The ID number can also be displayed by pressing and holding the main unit’s
ZONE2 SOURCE and TUNE + for at least 3 seconds.
0
If the upgrade is not successful, an error message identical to those in
“Firmware” - “Update” will appear on the display. Check the settings and
network environment and then perform the upgrade again.
Notes concerning use of “Update” and “Add New Feature”
0
In order to use these functions, you must have the correct system
requirements and settings for an Internet connection.
(v
p. 48)
0
Do not turn off the power until updating or upgrading is completed.
0
Approximately 1 hour is required for the updating/upgrading procedure
to be completed.
0
Once updating/upgrade starts, normal operations on this unit cannot
be performed until updating/upgrading is completed. Furthermore,
there may be cases where backup data is reset for the parameters,
etc., set on this unit.
0
If the update or upgrade fails, press and hold the X on the main unit for
more than 5 seconds, or remove and re-insert the power cord. “Update
Retry” appears on the display and update restarts from the point at
which update failed. If the error continues despite this, check the
network environment.
Information regarding the “Update” function and “Add New Feature” will be
announced on the Denon website each time related plans are defined.
Contents Connections Playback Settings Tips Appendix
199
Front panel Display Rear panel Remote Index

Table of Contents

Other manuals for Denon AVR-S900W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-S900W and is the answer not in the manual?

Denon AVR-S900W Specifications

General IconGeneral
Channels7.2
HDMI Inputs8
HDMI Outputs2
Wi-FiYes
BluetoothYes
4K Ultra HD Pass-throughYes
Dolby AtmosYes
DTS:XNo
HDMI Pass-ThroughYes
Input Impedance47 kOhm
Input Sensitivity200 mV
THD at rated output0.08%
Signal-To-Noise Ratio98 dB
DAC Resolution24-bit / 192kHz
HDMI SwitchingYes
AirPlayYes
DLNAYes
Dimensions17.1 x 6.6 x 13.3 inches
Power Output90 W
Response Bandwidth10Hz-100kHz
Output Impedance / Channel6 Ohm
InputsHDMI
OutputsHDMI
Supported Audio FormatsMP3, WMA, AAC, FLAC, WAV
Supported Video Formats4K
Output Power / Channel90W (8 ohms, 20Hz-20kHz, 0.08% THD)

Related product manuals