Denon AVR-X2200W Service Manual

1. Version Display Mode
1.1. Actions
Version information is displayed when the device is started in this mode.
1.2. Starting up
While holding down buttons "DIMMER" and "STATUS" simultaneously, press the power button to turn on the power.
then press the "STATUS" button to display the information in section 1.3 on the display.
b
The version list is also displayed on GUI while the version is displayed on the display.
1.3. Display Order
Error information("See 1.4. Error display") →
q
Model destination information →
w
Firmware Package Version
→
e
Main µ-com →
r
Main 1st Boot Loader →
t
DSP ROM →
y
Audio PLD →
u
GUI SFLASH
→
i
Ethernet 1st Boot Loader, Hardware ID →
o
Ethernet 2nd Boot Loader, Rhapsody Flag
→
Q0
Ethernet IMAGE →
Q1
Ethernet MAC ADDRESS information →
Q2
BT MAC Address information
q
Model destination information :
FLD
A V R - S 9 1 0 W E 3 *
FLD
A V R - X 2 2 0 0 W E 3 *
FLD
A V R - X 2 2 0 0 W E 2 *
FLD
A V R - X 2 2 0 0 W E 1 C *
FLD
A V R - X 2 2 0 0 W J P *
w
Firmware Package Version：
FLD
P a c k a g e : * * * *
e
Main µ-com Version information :
FLD
M a i n : * * * * # # # # *
*
： Main version,
#
： Sub version
r
Main 1st Boot Loader :
FLD
M a i n F B L : * * . * *
t
DSP ROM :
FLD
D S P : * * . * *
y
Audio PLD :
FLD
A u d i o P L D : * * . * *
u
GUI SFLASH :
FLD
G U I : @ @ $ \ * * * *
@
： Model code,
$
： Brand code,
\
： Region code,
*
： version
24

Denon AVR-X2200W Specifications

General

Channels	7.2
HDMI Inputs	8
HDMI Outputs	2
Dolby Atmos	Yes
DTS:X	Yes
Wi-Fi	Yes
Bluetooth	Yes
4K Ultra HD Pass-through	Yes
Audyssey MultEQ XT	Yes
HDCP Support	2.2
AirPlay	Yes
Ethernet	Yes
Phono Input	Yes
Total Harmonic Distortion	0.08% (20Hz-20kHz)
HDMI Version	2.0a
4K Support	Yes
HDR Support	Yes
Dimensions (W x H x D)	434 x 167 x 339 mm
Power Output per Channel	95W (8 ohms, 20Hz - 20kHz, 0.08% THD)
USB Input	1
Frequency Response	10Hz - 100kHz
Inputs	8 HDMI, 2 component
Outputs	2 HDMI, 1 composite, 1 component