Denon AVR-X4200W - Analog Video

2. Analogvideo
Performtheoperationbelowbeforehand.
b
Check it whether connection cable and Monitor are normal.
b
VIDEO Convert is set to ON.
b
Setting as follows.
V : SAT
COMPONENT : SAT
MONITOR OUT (CVBS/Cmponent/HDMI) output NG
Input
CVBS
To A
Input
COMPONENT
Input
CVBS,COMPONENT
A
Check of the I2C control signal for video selector IC
(IC511).
I2C(SCL) : BN21A-9 pin (AVSCL)
I2C(SDA) : BN21A-7 pin (AVSDA)
See the sample waveform page 103
(DIGITAL PCB)
Does the signal input to the video decoder(IC351)?
V : R3527
COMPONENT-Y : R3530
COMPONENT-Cb : R3528
COMPONENT-Cr : R3529
(DIGITAL PCB)
· Defective connection of FRONT CNT PCB.
(CN21A)
VIDEO PCB faulty. ⇒ B へ
· Defective connection of SIDE CNT PCB (BN77D).
· REGULATOR (SPEAKER) PCB aw.
DIGITAL PCB faulty.
Is the power voltage being output correctly?
V+5V : CN28B-6 pin
V-5V : CN28B-8 pin
(SIDE CNT PCB)
· CVBS Monitor Out is NG
COMPONENT Monitor Out is NG ⇒ To B
· HDMI Out is NG ⇒
To Troubleshooting "HDMI/DVI"
NO
NO
NO
YES
YES
YES
102