Denon DRA-F102 - Tone and Sound Adjustment

11
Operation
ENGLISH
ENGLISH
Operation
Turning the power on
Conducting playback
Adjusting the tone
To emphasize the low bass sound:
When “SDB ON/OFF” is displayed, use [
88
] or
[
99
] to select “ON” or “OFF”.
Adjusting VOLUME.
3
NOTE:
• Be sure to set to the proper function for the connected device.
<ON/STANDBY>
SDB/TONE
VOLUME
FUNCTION
FUNCTION
SDB/TONE
[POWER ON]
[POWER OFF]
VOLUME
[ 9 ]
[
8 ]
About the button names in this explanation
<>: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
Press
<
ON/STANDBY
>
or [POWER ON].
When the power is turned on, the function that was being used
when the power was last turned off is selected (selector
function).
¢ Turning the power off (to the standby mode):
Press
<
ON/STANDBY
>
again or [POWER OFF].
Use FUNCTION to select the input function.
1
CD/HDD
TAPEMD PHONOAUX (iPod)
TUNER PORTABLE IN
1
2
Use SDB/TONE to select the tone parameter to be
adjusted.
1
SDB BASS
S. DIRECT
TREBLE
BALANCE
SDB: Adjusts the low bass sound.
BASS: Adjusts the bass sound.
TREBLE: Adjusts the treble sound.
BALANCE: Adjusts the left/right volume balance.
S. DIRECT: The sound is played with the tone flat.
2
-1
To adjust the bass or treble sound:
When “BASS” or “TREBLE” level is displayed, use
[
88
] or [
99
] to adjust.
2
-2
To adjust the left/right volume balance:
When “BALANCE” is displayed, use [
88
] or
[
99
] to set the balance.
2
-3
•The tone is only flat when “S.DIRECT” is selected. To adjust the
tone controls set a made other than “S.DIRECT”.
•“S.DIRECT” can be used to bypass the tone control circuit for a
more pure sound.
•Power indicator
Power on ································Green
Standby mode·························Red
Low-power standby mode······Off
Timer standby mode···············Orange
When in the low-power standby mode, a very small amount of
power is consumed, even if all the indicators are turned off.
•The function can be selected by turning <FUNCTION> clockwise
or counterclockwise.
1
“PORTABLE IN” can only be selected when a portable player
is connected.
2
“iPod” is displayed instead of “AUX” when an Control Dock
for iPod is connected.
Start playback on the selected device.
For instructions on operating, see the player’s operating
instructions.
2