Denon DRA-F102 - Setting the Sleep Timer; Playing an Ipod; Setting the Low-Power Standby Mode; Setting the Time Display Time in the Standby Mode

17
Operation Operation
ENGLISH
ENGLISH
Setting the sleep timer
Example: Setting so that the power turns off in 80 minutes.
Press [SLEEP] during playback.
•The “SLEEP” indicator flashes.
Press [SLEEP] repeatedly while the “SLEEP”
indicator is flashing to select “80”.
•The “SLEEP” indicator stops flashing, remaining lit, after about
5 seconds.
The power is set to the standby mode after 80 minutes.
1
2
¢ Canceling the sleep timer :
Press [SLEEP] repeatedly to select “OFF”.
•The remaining time is displayed when [SLEEP] is pressed while the
sleep timer is operating.
•If [SLEEP] is pressed while the remaining time is displayed, “OFF” is
selected. Reset the timer as desired.
Press [iPod 1/ 3].
For remote control unit buttons that can be operated when the
function is set to “iPod”, see page 5.
Playing an iPod
®
Connect the Control Dock for iPod (ASD-1R) and
DRA-F102 ( page 10).
4
1
Use [CALL] to select the play mode.
3
Use FUNCTION to select “iPod”.
2
The music on an iPod can be played by using the Control Dock for
iPod (ASD-1R:Sold separately).
For details on the Control Dock for iPod, inquire at your store of
purchase or a DENON customer service center.
NOTE:
• The iPod may be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. It is illegal to
violate copyrights.
NOTE:
•DENON will accept no responsibility whatsoever for loss of iPod
data when using an iPod connected to the DRA-F102.
•Depending on the type of iPod or the software version, some
functions may not operate.
Browse Mode Remote Mode
10 SEC (Factory default):
The display automatically turns off after approximately 10 seconds.
CONTINUE:
Displayed continuously.
Browse Mode:
The menu and information on the tracks is indicated on the DRA-
F102’s display.
Remote Mode:
The menu and information on the tracks is indicated on the iPod’s
display.
Setting the low-power standby mode
Setting the time display time in the standby
mode
Use [
88
] or [
99
] to set.
Use MENU/SET to select “TIME DISPLAY”.
2
1
ON (Factory default):
Low-power standby mode.
OFF:
Normal mode.
Low-power standby mode (Eco mode)
Use [
88
] or [
99
] to set.
Use MENU/SET to select “ECO MODE”.
2
1
See page 11 for information on the power indicator.