Denon DRA-F102 - Conducting Timer Recording; CD Synchronized Recording;Synchronized Recording Function

ENGLISH
ENGLISH
19
System Operations System Operations
Use [8] or [9] to select “1_on / E_off”, then
press MENU/SET.
•The timer standby indicator “ ” lights.
The time is now set.
For details, see “Operation of the everyday and once timers”
( page 16).
6
Press <ON/STANDBY> or [POWER OFF].
•The power is set to the standby mode and the DRA-F102’s
power indicator lights orange.
When the timer start time is reached, playback starts from the
first track on the CD.
7
NOTE:
•If the current time is not set, the timer standby indicator “ ”
will not light.
•When the timer is set, the timer standby indicator “ ” lights.
•Be sure to set the power to the standby mode when you want
the timer to operate.
Example: Recording a radio program onto a cassette tape
Load the cassette tape onto which you want to record beforehand.
Be sure to load the cassette tape with the side onto which you
want to record at the top.
Use <REVERSE MODE> to switch the desired reverse
mode.
Use <DOLBY NR> as desired to select the Dolby Noise
Reduction system.
1
2
Press MENU/SET once.
•“TIMER” flashes.
5
6
Use <DIRECTION> to select the direction of
playback/recording.
3
Adjust the recording level and set the recording
mode.
For details, refer to the cassette deck’s operating instructions.
4
7
Use [8] or [9] to select “EVERYDAY” or
“ONCE”, then press MENU/SET.
Use [8] or [9] to select “TUNER
//
TAPE”,
then press MENU/SET.
Conducting timer recording
CD synchronized recording/
Synchronized recording function
This function lets you easily record the tracks from a CD onto a
cassette tape.
For instructions on operations, refer to the operating instructions
included with the cassette deck.
NOTE:
•No signals can be recorded on the leader tape at the beginning
of the cassette tape. To avoid missing the beginning, we
recommend setting the timer to start recording about 1 minute
before the program is scheduled to start.
•To conduct normal recording, turn off the timer standby indicator
“”.
8
Perform steps 4 ~ 8 under “Setting the everyday or
once timer” ( page 15, 16).
When the timer start time is reached, recording starts.
Perform steps 3 ~ 5 under “Setting the current time”
( page 15) to set the timer start time.
4
Perform steps 3 ~ 5 under “Setting the current time”
( page 15) to set the timer stop time.
5
3
Use [8] or [9] to select “CD”, then press
MENU/SET.