Denon RCD-N8

32
4.6. Accumulated laser on time display
When the Volume
f
button is pressed while this Unit is in the "CD TEST MODE "displayed, the accumulated laser on
time is displayed.
The laser drive times are added and the result is displayed.
One count corresponds to 10 minutes. The accumulated laser on time is displayed in hours. Displays up to 10922 hours.
Press the SOURCE button, CD TEST MODE display reappears.
The count values are not cleared, even when the set is reset (Factory/User).
Count value is reset
When the
1
/
3
ENTER button is pressed for over 5 seconds while the accumulated laser on time is displayed, the count
value is reset.
Count value is reset upon shipment from the factory and when the mechanism is replaced.
5. CDheatrunmode
Heat run mode Startup display
"Heatrun Mode" displayed for 5 seconds.
Press the Cursor
u
/
i
button to switch the mode. (H.R. Normal, H.R. Short, H.R. Chacking)
After loading the disc, press
1
/
3
ENTER button.
While heat run, the operation of each button is not valid If an error occurs, display the error and stop operation at that
point. Refer to Heat run error code table.
To exit this mode, unplug the power cord.
5.1. Normalheatrunmode
Playing from the rst track to last track on disc. After disc playback has nished, then tray open and close. And playback
again.
The heat run repetition no. is incremented (increased by 1) when the tray is opened.
Repeat this operation.
[H.R. Normal] displayed.
Select "H.R.Normal", and press
1
/
3
ENTER button.
Press the Cursor
u
button to display the count.