Denzel DCM-125 - Storage

18
CONCRETE MIXER
EN
STORAGE
Thoroughly clean the concrete mixer. Check connections and screws and tighten if necessary. Check that the concrete
mixer is not damaged. If necessary, repair it. To repair or replace parts, contact your service center. It is necessary to
store the concrete mixer in a dry place, at ambient temperature from 0 to + 40 °C and relative humidity of air no more
than 80%. Shelf life is not limited.
For the convenience of storage, saving space and transportation, after assembly of the concrete mixer, it can be folded
(for models DCM-160, DCM-180, DCM-200). To do this, follow the instructions below.
×1 B
M8×70 ×2
M6×25 ×1
×1
•
unscrew the nut M6 and pull out the bolt M6×25 at
the junction of the xing lever of the concrete mixer
with its extension;
•
pull from a loop situated on the frame of the stand
lock lever;
•
loosen 2 nuts M8 at the junction of the stand frame
with the frame.
M8×70 ×2 C
•
loosen 2 nuts M8 at the junction of the frame with
the axle for wheels with the frame;
•
holding hand behind the edge of the frame alter-
nately fold both sides of the structure.