02/20144 / 72
6159933910
Issue no: 04
7.1 - PC wiring diagram ....................................... 51
7.2 - Synchronizing several controllers................ 51
7.2.1 - Example of connection diagram ....................... 51
7.3 - Tool cables .................................................. 52
7.3.1 - EC / ERcable .................................................... 52
7.3.2 - MC cable .......................................................... 52
7.3.3 - EC - ER - MC extension cable ......................... 52
8.1 - PC2 format .................................................. 53
8.2 - PC3 format .................................................. 53
8.3 - PC4 format .................................................. 54
8.3.1 - Title ................................................................... 54
8.3.2 - Result ............................................................... 54
8.4 - PC5-A format ............................................... 55
8.4.1 - Report per spindle: torque rate, torque,
angle.................................................................. 55
8.4.2 - Reading results of spindle 1
(x times the number of spindles) ....................... 55
8.5 - PC5-B format............................................... 55
8.5.1 - Report per spindle: torque, angle,
torque rate ......................................................... 55
8.5.2 - Available parameters programmed for 1
spindle (x times the number of spindles) ........... 56
8.5.3 - Results of spindle 1
(x times the number of spindles) ....................... 56
9.1 - Torque control.............................................. 57
9.2 - Torque control and angle monitoring ........... 57
9.3 - Angle control and torque monitoring ........... 58
9.4 - Prevailing torque control.............................. 58
9.5 - Yield point controlled tightening .................. 59
9.6 - Loosening - torque control and angle
monitoring ................................................... 60
9.7 - Untightening - angle control and torque
monitoring ................................................... 60
9.8 - Seating detection......................................... 60
9.8.1 - Main phase: Seating detection ......................... 60
9.8.2 - Secondary phase : Post Seat ........................... 61
10.1 - Cycle ow chart ......................................... 62
10.2 - Cycle timing chart ...................................... 62
10.3 - Timing chart when using a crowfoot tool ... 63
11.1 - Warning ..................................................... 64
11.2 - Report codes ............................................. 64
11.3 - Operating problems due to adjustment
problems ..................................................... 67
11.4 - Operating problems due to wear or
breakdown ................................................... 68
To Next Page
Loading...
Need help?
General
