0044-0391-0M Rev A y solo Digital Clinical Scale
OPERATION, CONT.
Keypad Functions, Cont.
“ ” ZERO
This key is used to reset the display to zero. Note that if the “zero” key is
pressed with weight on the scale platform, the display will tare the weight and
change to .. When the weight is removed, the display will show a negative
weight value and then change to ..
“
” LOCK/RELEASE
This key is used to lock and unlock the display. Pressing this key will cause
the display to lock onto the weight and remain displayed after the patient
steps off the scale. Pressing the key again will unlock the display and return it
to zero.
NOTE: The scale will not respond to pressing the “ ” key unless the
weight is stable and the STA annunciator is turned on.
“
” BMI
The BMI key is used to input the patient’s height and then to perform the Body
Mass Index (BMI) calculation. Note that the scale will not respond to pressing
the key unless the weight is stable.
When using the solo height rod (or no height rod), pressing the key once
allows the operator to enter the height of the patient using the ©
or ª keys to
increment or decrement to the correct height. After entering the patient’s
height, pressing it again will display the Body Mass Index (BMI) calculation.
Pressing it a third time, will return the display to the patient’s weight.
NOTE: While the patient is still standing on the scale, pressing the “
” key
will toggle between BMI and weight display. Also, note that once the patient
steps off the scale, the display automatically returns to the weight only mode.
“
” UP ARROW
This key is used when performing the Body Mass Index (BMI) calculation to
increase the height value.
“
” DOWN ARROW
This key is used when performing the Body Mass Index (BMI) calculation to
decrease the height value.
During setup and calibration, the arrow keys are used to select setup
and calibration values.
To Next Page
Loading...
Need help?
General
