0044-0391-0M Rev A y solo Digital Clinical Scale
OPERATION, CONT.
Weighing Mode
1. Press the “ ” key. The scale will turn on and then display the software version for a few
seconds.
2. Next, a small
6
is shown and moves across the display until a stable zero is established.
3. After establishing zero, the scale will show . on display. Note that if the scale cannot
establish zero, the display will show 99 for a few seconds and turn the scale off.
4. Assist patient onto scale.
5. When the weight is stable, the weight reading will flash one time, a long beep will sound,
the reading will automatically lock and the LOCK annunciator will turn on. Note that the
lock will be released once the patient steps off the scale.
NOTE: If the weight increases or decreases more than 2kg while the weight reading is
locked, the locked weight will automatically be released, and the new weight will be locked
when it’s stable.
6. Press the “ ” key to hold the current weight reading. It will remain on the display after
the patient steps off the scale. Press the “ ” key again to release the current weight
reading.
(Released) (Hold)
7. Assist patient off scale.
8. To turn scale off, press the “ ” key.
If the Automatic Shutdown feature has been enable, the scale will turn off after a pre-
defined time of inactivity (no motion or weight on scale).
ALWAYS assist the patient when stepping on and off the scale platform to
ensure they do not fall. NEVER leave a patient unattended while they a
on the scale platform.
Failure to maintain control of the patient at all times
can result in serious injury to you and/or the patient.
To Next Page
Loading...
Need help?
General
