0044-0391-0M Rev A y solo Digital Clinical Scale
DISPLAY MESSAGES
The solo Digital Clinical Scale is equipped with software that tests various portions of the
scale's circuitry and verifies proper operation. Should a problem be detected, a message will
be displayed alerting the operator to that condition. The following lists the messages
displayed and their meaning:
This will be displayed for a few seconds when the scale cannot establish
zero
and then turn the scale off. Refer to the TROUBLESHOOTING
!6;`
Displayed when the batteries are near the point they need to be replaced.
Weight on scale exceeds 570 lb (260 kg).
TROUBLESHOOTING
Your scale has been designed to provide you with years of trouble-free operation. In spite of
this, troubles sometimes happen. Before calling for service assistance you should make
some initial checks to verify that a problem does exist. The following describes several types
of symptoms along with suggested remedies.
y Check if batteries are installed and correctly.
y Are batteries discharged? Remove old batteries and re
new ones.
y Is 9V AC/DC power adapter fully inserted into wall receptacle?
y
Check wall receptacle for proper AC power. Try another electrical
appliance in same receptacle, does it work?
y Check circuit breaker.
y
Has there been power failure?
Incorrect weight
displayed
Ensure that the scale platform isn't touching an adjacent object.
Have proper operation procedures been followed?
99
If platform is not empty (patient is on scale) when powering up, display
will
Remove any weight from platform (have
patient
step off scale) and power up the scale again.
If scale continues
to show
and turn off, consult your scale service representative.
Display shows a
moving small
6
display shows a moving small
6
when powering up, insure the
scale is stable and wait for a moment until the display shows
..
If scale continues to show a moving small
6
, please
consult your scale
service representative.
To Next Page
Loading...
Need help?
General
