0044-0391-0M Rev A y solo Digital Clinical Scale
SETUP
Your solo Digital Clinical Scale has been pre-configured at the factory and should not require
changes for use in most applications. However, if the factory settings do not meet the
requirements of your operation, the following describes the setup process for your scale.
To Enter Setup
1. With the scale off, press hold the “ ” key and then press the “ ” key to turn on
the scale.
2. The display will turn on all digits, show the software version for a few seconds and
then change to show 0-0f.
3. Release all keys.
4. The scale is now ready for setup.
"-0f (Minutes)
The display will show 0-0f, the current Minutes setting. If value displayed is
acceptable, press the “
” key to save it and proceed to the next prompt. Otherwise,
press the ©
or ª keys to select a new value from 00 to 59 and then press the “ ” key to
save it and proceed to the next prompt.
NOTE: The default minute setting is 00.
,,f (Hours)
The display will show ,,f, the current Hours setting. If value displayed is
acceptable, press the “
” key to save it and proceed to the next prompt. Otherwise,
press the
or ª keys to select a new value from 00 to 23 and then press the “ ”
key to save it and proceed to the next prompt.
IMPORTANT! Time is entered in a 24-hour format. When entering times after noon
(12:00 PM), you must add 12 to time. For example, 3:00 PM would be entered as 15.
NOTE: The default hour setting is 00 (mid-night).
(=f (Years)
The display will show ((f, the current Years setting. If value displayed is
acceptable, press the “
” key to save it and proceed to the next prompt. Otherwise,
press the
or ª keys to select a new value from 00 to 99 and then press the “ ”
key to save it and proceed to the next prompt. Note that 00 represents year 2000, 01
represents 2001 and so on.
NOTE: The default year setting is 00 (2000).
IMPORTANT: When a prompt and value displayed are acceptable, press
the “ ” key to save the setting and proceed to the next prompt. To
change a setting, press the
or ª keys to adjust the setting (or select a
new value) and then press the “
” key to save the new setting and
advance to the next prompt.
To Next Page
Loading...
Need help?
General
