Auto Humidity Reduction
Default is Off. When selected High or Low provides the
ability to minimize or reduce the window condensation
by reducing the humidity setpoint when the outside
temperature is cold.
Optimum – Comfort or Dehum
Default is Off. When Comf option is selected the
temperature is altered by the humidity to reflect the
true comfort. When Dehum option is selected humidity
reduction is maximized by continuing to cool below the
temperature setpoint.
Cycle Humidifier
Default is Off. When On, will cycle the humidifier on for 10
minutes and off for 10 minutes. This feature helps reduce
water usage.
EMR (Energy Management Recovery)
Default is On. With EMR selected On, the heating or
cooling system will start early so the temperature in your
home is at the desired temperature at the beginning of the
program period. If set to Off, the system will not start until
the beginning of the program period.
Maximum Heat Setpoint Temp – Default is 99°.
Minimum Cool Setpoint Temp – Default is 45°.
These settings are the highest temperature limit in Heat
mode or the lowest temperature limit in Cool mode.
Select a setting of 98° to 45° for the maximum heating
temperature or 46° to 99° for the minimum cooling
temperature.
Temperature Display Adjust
Default is 0°. Your thermostat was accurately calibrated at
the factory. However, this option allows you to change the
temperature displayed to match other thermostats in your
home.
16
To Next Page
Loading...
