To Next Page

To Previous Page

dS1242

dS1242 User Manual v4.10

Webpage security

The webpage security section allows you to prevent unauthorised personnel from accessing the

application webpage or using it to control the module.

Leaving the Security Password blank will disable it and allow everyone to access the application

page to control the module.

To enable password protection enter a password into the Password box. You can use any char-

acters from the ASCII character set from 0x20 to 0x7E except “ (0x22). It may be up to 200

characters long and you don't have to memorise it, so make it a long one with plenty of upper-

case, lowercase, numbers and symbols.

Accessing a special webpage, _pw.htm, will install the password on your browser. To do this

make sure the Enable _pw.htm box is checked.

When the “Update Pending” light goes out, re-boot the module and go to yourIP/_pw.htm

You will see something like this:

The password is now loaded on your browser. Do the same for any further browsers you want

to enable. When you have done uncheck the “Enable _pw.htm” box to prevent anyone else

from loading the password. When the “Update Pending” light goes out re-boot the module

Devantech dS1242 User Manual

Questions and Answers: