To Next Page

To Previous Page

dS1242

dS1242 User Manual v4.10

Sequencer commands

There are a set of 12 commands to control the sequencer.

The simplest of these is just a number which is the time delay in seconds.

1234 Numbers may be up 4093 seconds.

m500 This is the time delay in mS. There is a limit of Max. 4093ms.

M10 The time delay in minutes. There is a limit of Max. 4093 minutes.

H2 The delay in hours. There is a limit of Max. 596 hours.

U90 Unspecified delay in seconds. Its a random number up to the limit specified.

The Max. delay that may be specified is 4093 seconds.

T16:45 Waits until the specified time before continuing. Make sure you have an

internet connection and the clock is correctly set up on the Scheduler page.

At the start of all the delay commands above, the K outputs will be updated with

the specified settings, then after the delay time, the sequencer moves on to the

next line.

None of the following commands will update the K outputs. If you specify

anything in these check boxes they will be ignored. The instructions are executed

immediately with no delays.

J1 Jumps to the specified line.

C9 Calls the specified line. The sequencer has a 4 deep call/return stack. The line

following this one is pushed onto the stack and control transferred to the

specified line.

X eXit. Returns from a previous call. The line that was pushed onto the stack from

the last call is popped off and control transferred to that line. There are no

parameters to this command.

The following conditional jump commands take two parameters, the object

number and the line to jump to. They will jump to the specified line if the object

is active (on), otherwise continues with the next line. They do not stop and wait.

R1, 12 Tests R1 (Relay 1) and jumps to line 12 if active (on).

D1, 20 Tests D1 (Digital Input 1) and jumps to line 20 if active.

Devantech dS1242 User Manual

Questions and Answers: