11
A-DV56
EN
operAtion
NOTE– The additional control buttons that you see on the IntelliPAP control panel provide
advanced controls for specic settings. Please refer to the ‘Advanced Menu Controls’
section on page 12 for more details.
oPeRaTion
Startup
To begin operation, verify that your IntelliPAP is connected to a
‘live’ power source. When plugged in, the LCD display should
appear as noted.
Put on your CPAP mask and press the ON/OFF button on the keypad to turn on airow OR
put on your CPAP mask and take a few breaths to turn on airow automatically. The
pressure in your mask will rise to the set pressure in about 10 seconds.
NOTE
– If the device does not automatically start after taking 2-3 breaths, this feature may
have been disabled. If Auto ON/OFF is disabled, you must manually press the ON/
OFF button to start and stop the device.
The keypad display shows the actual mask pressure while the
device is in use. Because this is the actual pressure, the device
pressure reading may vary slightly as you breathe. Your display
should appear as noted.
If your DeVilbiss IntelliPAP system includes a humidifier, its heater
controls and status are displayed as noted in the image.
NOTE–
If the display on your device is not similar to those listed above, refer
to the chapter section titled “Patient Messages” on page 18.
Using The Comfort Delay Feature
Your IntelliPAP has a comfort delay feature to help make it easier for you to fall asleep. The
airow will start at a low pressure and then gradually ramp-up to the prescribed setting over
the last few minutes of the specified delay time.
NOTE
– When the delay comfort feature is activated, a message will ash on the display
periodically, indicating the amount of time remaining in the delay.
You can adjust the amount of time spent in comfort delay by using
the advanced device controls. The Delay Time can be adjusted
from 0 to 45 minutes in 5-minute increments. Refer to page 14 for
details.
Delay Running
10 Minutes Left
OFF
P:10.0 ST
P:10.0 ST
Heat:Off
To Next Page
Loading...
