DeVilbiss DV55 Bilevel Series - Patient Messages; Reminders; Notifications

18
A-DV56
EN
pAtient messAges
PaTienT messaGes
Your IntelliPAP will alert you of issues that may require some action on your part in order
to make your therapy more effective. These messages are displayed when the device is
turned on, either by pressing the ON/OFF button or by breathing into the mask. You can
press any key or button to clear the message from the display, but the IntelliPAP will
operate normally even if the message is not cleared.
Two kinds of messages are displayed: Reminders and Notifications.
Reminders
Reminders alert you when parts of your system need to be replaced. Some components of
your system wear over time and, if not replaced, may compromise your therapy. If you see
a message on the display that is not listed below, you may have the optional DeVilbiss
SmartLink™ Module attached to your device, which provides additional messages. Refer to
the documentation that was provided with the SmartLink Module.
Clean Filter – The filter should be checked every 10 days for signs
of dirt or wear so that it can be cleaned as needed. This message
helps to remind you to check it regularly.
Notifications
Notifications identify conditions in your IntelliPAP that may require action by you or your
home care provider in order to maintain a high level of therapy. If you see a message on the
display that is not listed below, you may have the optional DeVilbiss SmartLink Module
attached to your device, which provides additional messages. Refer to the documentation
that was provided with the SmartLink Module.
NOTE-The values displayed are examples only.
Delay Running xx Minutes Left – While a comfort delay session
is active, this message is ashed on the display every 5 seconds to
let you know how much time is left in the delay.
Mask Leak – This message means the IntelliPAP has detected a
large amount of airow during therapy for at least 10% of the time
during your previous use session. This notification is displayed when
the device is turned on. If this message is displayed, put on the mask and adjust the
headgear to ensure the mask is properly fitted to your face. Follow the mask manufacturer’s
directions for adjusting the mask and headgear for proper fitting. Available on Bilevel
models.
Mask Off – This message appears whenever a high airow
condition occurs. High airow is normally due to a poor mask t or
Mask Off. Please
check mask fit.
Delay Running
10 Minutes Left
Clean Filter
Mask leak =
25 % Check Fit.