DeVilbiss DV55 Bilevel Series - Bilevel Patient Menu; CPAP Patient Menu

17
A-DV56
EN
ADVAnceD menu controls
DV55/DV56 Bilevel Patient
Menu Layout
The following charts shows by Mode each Display
you will scroll through using the Next or Previous
buttons on the keypad. Pressing the Down key at
the Enable Menu Display will allow you to enter
this submenu - then use Next or Previous buttons
to scroll through it; press the Up button to return
to main menu. Once the final Display is reached,
pressing the Next button will return you to the
first Display.
Auto-OFF 
Enabled
Auto-ON 
Enabled
Low Backlight
Enabled
Exit Menu
Press 
Mask Fit Check
Enabled
MENU - CPAP Mode
P:10.0 CPAP
Heat:5
Set Pressure
10.0 cmH2O
Delay Pressure
5.0 cmH2O
Compliance Meter
123456.7 hours
Serial Number
KD123456
Hourmeter
123456.7 hours
Firmware Version
V0.11 21/08/2009
LCD Contrast Adj
50%
Delay Time 
10 minutes
Enable Menu
Press 
SmartCode 1-Day
G201-0Y7-6GPH
Tubing Length 
1.8 m (6 ft)
Adherence Score
83% (25/30)
MENU - Bilevel Mode
P:10.0 ST
Heat:Off
Compliance Meter
123456.7 hours
Serial Number
KD123456
Hourmeter
123456.7 hours
Firmware Version
V0.11 21/08/2009
LCD Contrast Adj
50%
Auto-OFF 
Enabled
Auto-ON 
Enabled
Low Backlight
Enabled
Enable Menu
Press 
Tubing Length 
3.0 m (10 ft)
Exit Menu
Press 
Delay Time 
45 minutes
SmartCode 1-Day
FZA4-99D-D6WH
Adherence Score
70% (21/30)
NOTE: Mode can read S,
T or ST
P:10.0 S
–
T RR:15
I/E: 1:1.0 (50%)
LK:123 S
–
S EV:AS
MV:123.4 VT:1234
IPAP
10.0 cmH2O r 5.0
EPAP
5.0 cmH2O r 5.0
Delay Pressure
5.0 cmH2O
Exp. Trigger 
5
Backup Rate
15 BPM
I/E Ratio
1 : 1.0 (50%)
Insp. Trigger 
5
EPAP Rounding 
0 (1234 ms)
IPAP Rounding 
0 (1234 ms)
Mask Fit Check
Enabled
Bilevel S & ST Modes Only
Bilevel S & ST Modes Only
Bilevel ST & T Modes Only
Bilevel ST & T Modes Only
P:10.0 S
–
T RR:15
I/E: 1:1.0 (50%)
LK:123 S
–
S EV:AS
MV:123.4 VT:1234
NOTE: There are 5 levels of
SmartCode. Use up  or down
 key to change between levels.