12
SE-DV53-1
EN
opEration
Using The Comfort Delay Feature
Your SleepCube has a comfort delay feature to help make it easier for you to fall asleep. The
airflow will start at a low pressure and then gradually ramp-up to the prescribed setting over
the specified delay time.
When the delay comfort feature is activated, a message will ash on the display
periodically, indicating the amount of time remaining in the delay.
You can adjust the amount of time spent in comfort delay by
using the advanced device controls. The Delay Time can be
adjusted from 0 to 45 minutes in 5-minute increments. Refer to
page 14 for details.
If you are unable to change the delay time, your provider has locked this setting. Refer
to the keypad menu guide on page 14 for details.
Comfort Delay Feature In Standard CPAP Mode
When you use the comfort delay feature while your device is operating in CPAP mode, the
airflow you receive at the beginning of your therapy is temporarily lowered to a pressure
selected by your physician when the device was setup.
Press the delay button to activate the comfort delay feature. The airflow pressure will drop to
the prescribed comfort delay pressure.
During the delay period, the pressure will gently rise to the pressure prescribed for your
therapy. You may repeat the comfort delay by pressing the delay button again if you have
not fallen asleep.
Using The SmartFlex Feature
Your SleepCube has a SmartFlex pressure relief feature to help
make it easier for exhale against your prescribed pressure by
lowering the pressure slightly when you exhale. The pressure
returns to your prescribed pressure during inhale to maintain your therapy.
SmartFlex pressure relief includes three settings for exhale relief; 1, 2, and 3. (1 is the least
amount of relief, 3 is the most amount of relief). Setting SmartFlex pressure relief to zero
(0) turns the SmartFlex feature OFF.
The pressure waveform can also be adjusted independently for inhale and exhale to smooth
the transition when SmartFlex pressure relief is active. The pressure waveform settings are
SmartFlex-i (IRnd) and SmartFlex-e (ERnd) with settings from 0 to 5 in steps of 1 (0 is the
least amount of smoothing, 5 is the most amount of smoothing).
P:10.0 FLX CPAP
Heat:Off
Delay Running
10 Minutes Left
To Next Page
Loading...
