26
SE-DV53-1
EN
clEaning
sleePCUbe CleaninG
� Warning
To avoid electric shock, always unplug the power cord from the wall outlet
power source before cleaning.
Never rinse or place the device in water. Never allow liquids to get into
or around any of the ports, switches or air lter; doing so will result in
product damage. If this occurs, do not use the device. Contact your
home care provider for service.
Device Cabinet
1. Unplug the SleepCube from the power source. Wipe the enclosure with a clean, damp
cloth every few days to keep the enclosure dust free.
2. Allow the device to dry completely before plugging it into a power source.
Filters
Air-Inlet Filter (Standard)
1. The air-inlet filter should be checked every 10 days and cleaned as necessary. The filter
is located in the rear of the device.
Proper lter function is important for the operation of the device and to
protect the device from damage.
2. To clean, remove the dark outer foam filter from the frame.
3. Wash the filter in a solution of warm water and dishwashing detergent, and rinse with
water. Allow the filter to dry completely. If the filter (part #DV51D-602) is damaged,
contact your home care provider for a replacement.
4. Ensure the filter is completely dry before installation and use.
Fine Particle Filter (Optional)
1. If you have an optional fine particle filter (part #DV51D-603), inspect this filter and
replace it if it shows signs of dirt or damage. Do not wash.
2. Install the fine particle filter behind the standard filter.
If the ne particle lter is not installed rst according to the directions, the life of the
lter will be reduced requiring more frequent replacement.
To Next Page
Loading...
