DFI BT551 - BIOS Display and SATA Configuration; IGFX Boot Display Settings; SATA Controller Configuration

Chapter 3
www.dfi .com
32
Chapter 3 BIOS Setup
Primary IGFX Boot Display
Select the Video Device which will be activated during POST. This has no effect if the
external graphics presents. The selection of secondary boot display will appear based
on your selection. VGA modes will be supported only on primary display.
Secondary IGFX Boot Display
Select the secondary display device: CRT, DDI-0 or DDI-1. DDI-0 is the default setting.
SATA Configuration
This section is designed to select the SATA controller and the type of hard disk drive which are
insalled in your system unit.
DISABLED: Disables
SATA controller.
ENABLED: Enables SATA
conroller.
SATA Controller
Advanced
F1 Help ↑↓ Select Item F5/F6 Change Values F9 Setup Defaults
Esc Exit ←→ Select Menu Enter Select

SubMenu F10 Save and Exit
InsydeH20 Setup Utility Rev. 5.0
<Enabled>
SATA Controller
Enable or disable the Serial ATA Port.