106
3
BIOS Setup
NVRAID BIOS
The NVRAID BIOS utility is used to configure and manage RAID on
Serial ATA drives (SATA 1 to SATA 4) and Parallel ATA drives.
After you power up the system and all drives have been detected,
the NVRAID BIOS status message screen will appear. Press the
<F10> key to enter the utility. The utility allows you to build a RAID
system on Serial ATA drives and Parallel ATA drives.
Important:
• Before creating RAID, make sure you have connected Serial
ATA drives and Parallel ATA drives.
• Set the “IDE RAID” field to Enabled (Integrated Peripherals
submenu, RAID Config section of the Award BIOS.)
• Enable the IDE and/or Serial ATA drives you want to
configure as RAID (Integrated Peripherals submenu, RAID
Config section of the Award BIOS.)
To Next Page
Loading...
