Handling, Care,
Maintenance
DV 20 E AFM
Page 8 - 8 Rev. 2 22-Mar-2022 Doc. No. 4.01.25-E
Control Surfaces Gust Lock
The primary controls can be blocked by a control surfaces gust lock. It is recommended
that the control surfaces gust lock be used when parking outdoors, because otherwise
the control surfaces can hit the stops in strong tail wind. This can lead to excessive wear
or damage.
WARNING
The control surfaces gust lock must be removed before flight.
The control surfaces gust lock is installed as follows:
1. Move the rudder pedals fully rearward. Pull straight back on the T-grip, do not
pull up.
2. Engage the control surfaces gust lock with the pedals.
3. Engage the stick, wrap straps around stick once.
4. Attach the locks and tighten the straps.
For removal, reverse the sequence.
NOTE
It is recommended to cover the canopy when the airplane is
parked outdoors, in direct sunlight, at outside air temperatures
above 25°C (77°F), in order to prevent excessive heat
generation within the instrument panel which can cause
damage to the equipment.
To Next Page
Loading...
