2.1. Turning your Sensor ON/OFF
Turning Your Sensor On
To turn your sensor on when it is on your bat, tap the bat on the ground a couple times! This will wake up
the sensor and it will start to blink rapidly. Once the sensor is paired to your device, the light will slow to a
pulse.
You can turn the sensor on when its is off the bat by tapping the top of the sensor a couple times or placing
it on the charger.
Turning Your Sensor Off
1. With your sensor paired to the device, navigate to the Pair Sensor Page from the main menu of the
app.
2. Select the ‘i’ to the far right of your SwingTracker
3. This next page is your Sensor Information, you’ll see an option that says Turn Sensor Off
The sensor will turn off automatically if the sensor does not move for 15 minutes.
Diamond Kinetics SwingTracker - 1
Page 9 of 107
To Next Page
Loading...
