2.3.2. Pairing Your Sensor through Apple
Settings
Let’s get your SwingTracker Paired!
For users who purchased the SwingTracker before December 1st, 2020.
1. Double tap the sensor to turn it on (a rapid blinking green light will appear)
2. Go to Settings on your iOS device
3. Select BlueTooth
4. Enable Bluetooth in the Settings Menu, if it is not already on
5. Select the “SwingTracker” sensor
6. Look for “Connected” next to the SwingTracker
“I don’t see my SwingTracker in my BlueTooth Devices”
• Confirm that the sensor is on (no light means it’s not on)
• Confirm that the sensor is charged (red light means it is low on charge)
• Check that it is not connected to another nearby iOS device
• Confirm SwingTracker is close to the iOS device and try again
Diamond Kinetics SwingTracker - 1
Page 14 of 107
To Next Page
Loading...
