2.7. Attaching to the Bat
With your SwingTracker, you should receive a green rubber strap. You can use this to attach the sensor and
pod to your bat.
To attach the sensor to the bat:
1. Place it in the pod by pushing down and turning clockwise
2. Place the green strap on the bat by stretching the center whole over the knob of the bat
3. Place the pod and sensor in the center of the pod
4. Pull each of the arms on the strap up over the wings of the pod so that the wing goes through one of
the holes on the arm
You’re good to go!
Diamond Kinetics SwingTracker - 1
Page 21 of 107
To Next Page
Loading...
