Transmitters 9 November 2001 99
Next Chapter
Tran sm it te r
If a transmitter is linked to a return receiver in the same shelf,
Auto Shutdown is now set. If a transmitter is linked to a
return receiver in another shelf, connect the shelves by
plugging one end of a ribbon cable into the manual shutdown
connector on each shelf.
See the Receivers section of this Diamond Transport manual
for more information on setting up receivers for Automatic
Shutdown.
Proceed to “Installing a Transmitter in the DT Shelf” on
page 102.
Figure 43. Switch Settings
Set switches SW2 and SW3 to correspond with communication
line shared by the transmitter and receiver. Switches are
factory-set to 0.
To Next Page
Loading...