24
˂ 15º
15º max
DECK FITTING (CHARLIE NOBLE) INSTALL Cont’d
The Dickinson Deck Fitting
The deck fitting can be installed on sloped or angled surfaces if the pitch does
not exceed 15° (A) If the angle is greater than 15° A leveling block or spacer
must be used - fig 29
A levelling block or spacer must be shaped or constructed from suitably
durable material such as hardwood (B) or sheet metal (C)
It’s construction can be solid or hollow, but a 1 inch gap around all the way
around the chimney pipe must be ensured. The chimney pipe itself must not
come into direct contact with the block or be too narrowly confined within it.
A
B
1 inch air
gap
1 inch air
gap
C
D
E
F
Levelling Blocks
Must be customized to adequately accommodate the install surface. For
this reason it is not possible to order a levelling block from Dickinson.
A Shipwright, carpentry shop or sheet metal fabricator are good places
to source a custom levelling block.
Non-Compliant installs
Installs at angles (E) exceeding 15º, vertical installs (F) and installs that do not conform to the
instructions in this manual are not supported.
Please note that Dickinson bear no responsibility for unsatisfactory performance damage or loss resulting
from non-conforming product installations that do not meet the requirements in this manual.
Depiction of metal
deck fitting spacer
Depiction of hardwood
deck fitting spacer
FIG 28
FIG 29
FIG 35
To Next Page
Loading...
