14
2. Press and OFF (or the first start time programmed) begins flashing.
3. To set the desired first start time hour (note AM and PM designations), press
or .
4. Press and the minutes start flashing.
5. Press or and set the desired start time minutes.
6. Press again, the second start time and OFF or the last start time
programmed appear flashing. Repeat the steps to set the second, third, and if
needed,the fourth start time. During programming, if you are set to water on
specific days of the week, the screen also shows which days the controller will
operate with an underline.
To delete a start time:
1. Press until START 1 appears.
14
To Next Page
Loading...
